Xylem HYDROVAR Smart - Manual (Page 37)

37
7.28 Submenu for manual test run
S U B M E N U
TEST RUN man.
Press ¾ for about 3 seconds to enter the submenu
and the display changes to
7.28.1 Activate manual test run
TEST RUN man.
П + Р
By simultaneously pressing П + Р a test run will
be released.
The function and operation of the started manual test run is similar to the automatic
test run
Press ¾ on the Hydrovar-Smart to change to
7.28.2 Test Frequency
TEST-FREQUENCY
30.0 Hz
Frequency for manual and automatic test run.
Can be set from 6.0 Hz up to 70,0 Hz
Press ¾ on the Hydrovar-Smart to change to
To leave the submenu press the ¾ longer than 3 sec. to change to
S U B M E N U
TEST RUN man.
Press ¾ on the Hydrovar-Smart to change to
7.29 Submenu - Error
S U B ME N U
ERRORS
Press ¾ for about 3 seconds to enter the submenu
and the display changes to
7.29.1 Conveyor Limit
CONVEYOR-LIMIT
disabled
Disabled or adjustable between 0.00...SENSOR
RANGE. To disable the conveyor limit, press Ð till
“disabled” or “0 bar” is shown on the display.
An adjusted value >0 has to be reached till the programmed “DELAY TIME”.
Doesn’t this value be reached; the failure “VAL. RANGE CONTR.” will be indicated and
the pump stops.
Press ¾ on the Hydrovar-Smart to change to