Xylem HYDROVAR Smart - Manual (Page 20)

20
7 Settings in the Secondary Menu
Important! Before entering the secondary menu, these instructions
have to be read carefully to prevent incorrect settings which could cause
malfunction.
Secondary Menu:
INVERTER STOP
ON -> START
Stop motor by pressing Ð (OFF)
PASSWORD
0000
Press ¾ for 3 seconds to change to
PASSWORD
0066
Set ‘Password 0066’ by pressing Ï
Note: The password must be entered at each entry!
J O G – MODE
0.0Hz X.XX Bar
Confirm by pressing ¾ and the first window of the sub
menu is shown
In the following paragraphs all possible settings are listed (in the display, there
is shown the European default setting).
7.1 JOG-MODE
Display and Manual Operation Mode
J O G – MODE
0.0Hz X.XX Bar
Actual outgoing frequency and actual analogue input
are shown. By pressing Ï or Ð in this menu, the
internal controller of the Hydrovar-Smart will be shut off and the inverter changes to
manual mode. With the buttons Ï and Ð you can set any constant speed.
Setting of 0,0 Hz stops the inverter. If the JOG-MODE is left at a frequency higher than 0,0
Hz the inverter will continue its normal automatic operation.
Press ¾ on the Hydrovar-Smart to change to
7.2 Window - %
WINDOW
5%
This value indicates the max. variation of the outgoing
pressure.
Possible setting: between 0% - 100% of required value.
Press ¾ on the Hydrovar-Smart to change to