YSI 5200 - Manual (Page 36)

YSI Incorporated 34 5200 Recirculating System Monitor
C o n d 2 4 . 0 m S *
S a l . 1 0 . 4 p p t
The status LEDs show the current status of each parameter as follows:
OFF – parameter not enabled
GREEN – normal range
FLASHING GREEN – control mode (turns off when it crosses the original set point)
RED – alarm (turned off by pressing any key, except escape, and resolving the alarm condition)
5.2 Main Menu
Run Screen
Service Hold System Menu Param eter Menu Tim er Menu
Figure 5-1 Main Menu
From the Run screen, press the Enter [  ] key to enter the Main menu.
S e r v i c e H o l d
E n t e r t o S e l e c t
NOTE: Service Hold is the first selection in the Main menu. It allows you to perform service operations
(clean probes, provide tank maintenance etc.) without breaching any alarms or set points. See
Section 9.2.2 Service Hold.
Press the [e] or [f] key to rotate through the Main menu selections.
P a r a m e t e r s
E n t e r t o S e l e c t
The menus are displayed in the order indicated in Figure 5-1, starting with Service Hold. You can cycle
through the menus as many times as you desire in either direction using the arrow keys.
NOTE: Entering the menus automatically turns off all 4 internal control relays.
Indicates temperature
compensation