Extron Electronics JMP 9600 User Guide - Manual (Page 108)

Cleaning the Air Filters
The JMP 9600 is equipped with two foam air filters that should be checked every four to
six months and cleaned or replaced as required. You may need to perform this check more
frequently in environments containing higher levels of particulates (such as dust).
CAUTION: Do not subject the player to excessively dusty environments.
Clean the air filters as follows:
WARNING : Physically disconnect both power cables from the player before removing
the front panel.
1. Unplug both power cords.
2. Remove the eight front panel screws to access the foam filters.
3. Gently lift each filter from the receptacle.
4. Use compressed air or a vacuum cleaner to remove any accumulated dust.
NOTES: • If dust remains, you can pass the filters under warm running water or
gently immerse them in warm soapy water. Ensure the filters are rinsed
and completely dry before reinstalling.
• If the air filters are damaged, contact Extron for replacement
(part number 100-639-01LF).
5. Re-insert the filters into the receptacles on the unit.
6. Replace the front panel and secure it with the screws that were removed in step 2.
7. Restore power.
JMP 9600 Media Player • Mounting and Maintenance 102