Extron Electronics JMP 9600 User Guide - Manual (Page 55)

Network Ethernet setup dialog boxes
1. Select Network > Ethernet 1 or Network > Ethernet 2 to
open the selected Ethernet setup dialog box (see figure 50).
Figure 50. Ethernet Setup Dialog Box
2. For the IP Address and Netmask (subnet mask) fields:
a. Click in the desired field.
b. Edit the address as desired.
3. Click the Mode drop-down box and select either
Static or DHCP .
4. Click the Save button.
5. Click the to close the dialog box.
Network Gateway setup dialog box
1. Select Network > Gateway to open the Gateway dialog box
(see figure 51).
Figure 51. Gateway Setup Dialog Box
2. Click the Mode drop-down box and select
either eth0 or eth1 .
NOTE: eth0 = LAN port 1.
eth1 = LAN port 2.
3. Edit the address as desired.
4. Click the Save button.
5. Click the to close the dialog box.
JMP 9600 Media Player • HTML Operation 49