Extron Electronics JMP 9600 User Guide - Manual (Page 118)

Player sync
External sync in (genlock) ............... 1 Vp-p, bi-level or tri-level
Genlock connectors ........................ 1 female BNC (genlock in, black burst)
2 female 6-pin mini DIN (LOCK proprietary genlock in and out, for connection to
other JMP 9600 units)
Time code
Signal level ..................................... Input impedance: 600 ohms
Input level: >100 mVp-p
Output level: 1 Vp-p
Rates
JMP 9600 HD models .............. 1 SMPTE, EBU, film output on a female RCA connector (tip-sleeve)
JMP 9600 2K models ............... 2 SMPTE, EBU, film (input and output) on a pair of female RCA connectors (tip-
sleeve)
Sync— analog video outputs
Output type ................................... For analog output: RGBHV
Output level ................................... 2.75 V to 3.3 Vp-p, unterminated for RGBHV
Output impedance ......................... RGBHV: 75 ohms
Output polarity ............................... H negative, V negative
Audio processing
Processing ...................................... 24 bit, 48 kHz sampling
Digital audio output
Number/signal type ........................ 8 AES/EBU (16 channels, unbalanced, uncompressed)
Connectors .................................... 8 female BNC
Impedance ..................................... 75 ohms
Nominal level ................................. 0.5 V to 1.5 Vp-p
Attenuation range per channel ....... 0 to -144 dB
Control — host ports — JPEG video player
Serial host control ports .................. 2 bidirectional RS-232, female 9-pin D connectors: 1 for control, 1 unused
Baud rate and protocol ................... 300 to 115200 baud (115200 baud = default); 8 (default) or 7 data bits;
1 (default) or 2 stop bits; no parity (default), or even or odd parity
Serial control pin configuration ....... 2 = Tx, 3 = Rx, 5 = GND
Ethernet host port .......................... 2 female RJ-45
Ethernet data rate .......................... 10/100/1000Base-T, half/full duplex with autodetect
Ethernet protocol ........................... ICMP (ping), IP, TCP, DHCP, HTTP, Telnet, FTP
Ethernet default settings ................ IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Default gateway = 0.0.0.0
DHCP = off
Storage
JMP 9600 HD, JMP 9600 2K
Hard drives ......................... (2) 500 GB hard drives, RAID 0
JMP 9600 HD 128, JMP 9600 2K 128
Solid state drives ................ (2) 64 GB solid state drives, RAID 0
Program control ............................. MSVPP command set
Microsoft ® Internet Explorer ® , Apple ® Safari ® , Mozilla ® Firefox ® , Telnet
Software encoder ........................... J2KENC and J2KENC-PRO
JMP 9600 Media Player • Reference Information 112