Setting the clip or playlist to, Autoplay and view clip info – Extron Electronics JMP 9600 User Guide User Manual

Page 48

Advertising
background image

Setting the clip or playlist to autoplay and view clip info

NOTE:

•

The player must be correctly configured for the clip or playlist that you select

using the

Setup > Video > Mode dialog box submenu

, or else the player

does not load the selected clip or playlist.

•

If you cannot get a clip to load, See “

Setting the clip or playlist to

autoplay and view clip info

“ to view the properties of the clip, which can

help reveal the problem.

•

This page lets you set a clip file to autoplay only. To view and clear an

autoplay selection, use the

Autoplay Setup Dialog Box

.

•

If you load a new clip with a different resolution and frame rate than the

currently loaded clip, it can take up to 4 seconds before it is ready to play.

The autoplay feature sets a specified clip or playlist to automatically start playing for
channel 1 or channel 2 whenever the media player powers up and has loaded its operating
system. Enable a clip or playlist to autoplay as follows:

1.

In the Media Browser panel, right-click the file that you want to autoplay (see

a

in

figure 39). A dialog box appears.

1

2

3

4

Figure 39.

Loading a Clip or Playlist

2.

Click

Set as Autoplay

(

b

). The Set Autoplay dialog box appears.

NOTE: Alternatively, you can click

View

Clip

Info

to open a dialog box that

shows details of the file, including:

•

The file name

•

The issuer (creator)

•

The issue (creation) date

•

The bit rate

•

The resolution and frame rate

•

The color depth

•

The chroma subsampling rate

•

The number of audio channels

•

The audio width

Click the to close the View Clip Info dialog box.

3.

Select either the

Channel

1

or

Channel

2

check box (

c

).

4.

Click the

Ok

button (

d

).

JMP 9600 Media Player • HTML Operation

42

Advertising