Extron Electronics JMP 9600 User Guide User Manual
Page 67
Command/response table for MSVPP commands (continued)
Command
MSVPP Command
(host to unit)
Response
(unit to host)
Additional description
Media management (continued)
Load the next clip to
play
LoadNextClip•
X#
•
X!
/
X@}
OK
]
Load a clip to play automatically after the clip that is
currently playing in channel
X#
ends. If
X!
and
X@
are
not values returned by the GetMediaTree command
and GetMediaClips command, or if the media player is
not correctly configured for the clip that you select, the
media player responds with ERROR.
NOTES:
•
If you send multiple LoadNextClip commands, each overwrites the one before it; only the most recently loaded clip is available to be played.
•
If the folder name (
X!
) and the clip name (
X@
) contain any spaces (•), the entire set of parameters must be enclosed in quotes (“
X!
/
X@
“), for example:
LoadNextClip•1•”720p_422_60_rafting/river•rafting.cpl.xml
}
”.
Create a playlist
CreatePlaylist•
X$}
OK
]
Example:
CreatePlaylist•Canyon documentary.espl.xml
}
Create a Canyon documentary playlist.
OK
]
NOTE: Clips within a playlist must have the same resolution and frame rate.
Add a clip to a playlist
AddPlaylistItem•
X$
•
X!
/
X@
•
X%}
OK
]
Add the clip file
X@
, in the folder
X!
, to playlist
X$
at
position
X%
. The clip previously at position
X%
, and all
clips after it sequentially, slip by one position. If you
specify a position (
X%
) that is larger than the number
of clips in the playlist, the clip goes at the end. If the
playlist does not already exist, the media player creates
it automatically as it executes the command.
Example:
AddPlaylistItem•River activities.espl.xml•720p_422_60_kayak/kayak_720p_5994.cpl.xml•2
}
OK
]
Add a clip on kayaking to the playlist on river activities.
The kayaking clip plays second. Create the playlist
“River activities.espl.xml” if it does not exist.
NOTE: After you add a clip to a playlist, you need to load or reload the playlist before you can access or play the clip.
Move a clip in a playlist
MovePlaylistItem•
X$
•
X%
current
•
X%
new
}
OK
]
Move the clip file in position
X%
current
to position
X%
new
.
Clips in between the two positions move up to fill the
empty space.
Example:
MovePlaylistItem•River activities.espl.xml•2•4
}
Move the clip in the second position in the river
activities the playlist to the fourth position.
OK
]
KEY:
X#
= Output
1 = channel 1
2 = channel 2
1,2 = both channels
X!
= Folder name
Name of a DCP folder (such as “720p_422_60_donkey“)
X@
= Clip name
Name of a clip file (such as “rafting_720p_5994.cpl.xml“)
X$
= Playlist name
Name of a playlist file (such as “Canyon documentary.espl.xml”)
X%
= Playlist position
Sequential position of a clip in a playlist
JMP 9600 Media Player • Pr
ogramming Guide
61