Extron Electronics JMP 9600 User Guide - Manual (Page 16)

RJ-45 connector wiring
The Ethernet cable can be terminated as a straight-through cable or a crossover cable and
must be properly terminated for your application (see figure 6).
• Crossover cable — Direct connection between the computer and the media player
• Patch (straight) cable — Connection of the media player to an Ethernet LAN
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable. A cable that is wired the same at both ends is
called a "straight-through" cable, because
no pin/pair assignments are swapped.
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins: Crossover Cable Straight-through Cable
Pin
1
2
3
4
5
6
7
8
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
T568A T568B
End 1 End 2 End 1 End 2
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
Pin
1
2
3
4
5
6
7
8
Wire color
White-orange
White-green
Blue
White-blue
White-brown
Brown
Wire color
T568B T568B
White-orange
Orange Orange
White-green
Blue
White-blue
Green
Green
White-brown
Brown
Figure 6. RJ-45 Connector and Pinout Tables
Remote Control Port
h Remote (RS-232) port 1 — Connect a host device, such as a computer, touch panel
control, or RS-232 capable PDA to the player via this male 9-pin D connector for serial
RS-232 (see figure 7) control or pass-through.
RS-232 Function Pin
1
2
3
4
5
6
7
8
9 —
TX
RX
—
Gnd
—
—
—
—
Not used
Transmit data
Receive data
Not used
Signal ground
Not used
Not used
Not used
Not used
5 1
9 6
Figure 7. Remote 1 Port
See “ Programming Guide “ for definitions of the MSVPP commands (serial commands
to control the media player via this connector).
Snap one of the included ferrite beads on the Remote cable, as close to the unit as
possible.
NOTES: • Unlike products that were designed by Extron, former Electrosonic
products use a male connector. You may need an adapter.
• Serial port Remote 1 can be set to ControlMSVPP (control the player),
Passthrough (pass the signals through to a controlled device), or Disabled.
• The media player can:
• Operate at 300, 600, 1200, 1800, 2400, 4800, 9600, 19200, 38400,
57600, or 115200 baud rates
• Use 7 or 8 data bits
• Use no parity, even parity, or odd parity.
• Use 1 or 2 stop bits
• Serial port Remote 2 is for factory use only. The customer or end user
cannot control the player via the Remote 2 port.
JMP 9600 Media Player • Installation 10