Alpha Technologies AlphaGen PN-6x-T 7.5kW 48VDC - Technical Manual - Manual (Page 38)

38 042-288-B0-001, Rev. A
Fig. 3-9, Pallet Bolt Locations, PN-6x-T 7.5kW
3.0 Installation, continued
3.3 PN-6x-T 7.5kW Installation, continued
3.3.1 PN-6x-T 7.5kW Transportation and Lifting,
The enclosure as shipped contains the Auxiliary Power Unit (APU) and weighs
approximately 338 lbs. A safe means of transporting to the site, and unloading the
enclosure must be considered. Do not transport, lift, or place the unit on any surface
unable to fully support its weight.
The system is shipped bolted to a pallet. Once the system arrives, remove the
protective outer wrapping material and inspect the outside of the enclosure for
shipping damage. Use a forklift to place the unit (still bolted to its pallet) in the back of
the transport vehicle for delivery to the installation site. Once on site, attach the lifting
plates to the enclosure at the holes indicated below. Remove the front and rear doors
and remove the pallet mounting bolts using a 5/8" socket wrench.
Pallet Mounting Bolt
(hidden)
Pallet Mounting Bolt
(hidden)
Lifting Plate
Mounting Holes
Lifting Plate
Mounting Holes
Do not install the ignition battery until the enclosure is placed in its permanent location.
CAUTION!