B&K Precision 4040B - Manual - Manual (Page 27)

27
1
To select the output mode, press MODE, then press the
function key that corresponds to the desired Mode menu
option, as shown:
Mode Menu
F1: Continuous
– Selects continuous output.
F2: Triggered
– Triggers one output cycle of the
selected waveform for each trigger event.
F3: Gated
– Triggers output cycles as long as the trigger
source asserts the gate signal.
F4: Burst
– Triggers ‘N’ number of output cycles for each
trigger event, where N ranges from 2 to 65,535.
Note: Gate and Burst modes are not available on
4014B.