2 setting the output, 3 using voltage offset, 4 storing and recalling a waveform generator setup – B&K Precision 4040B - Manual User Manual
Page 40
40
* Selecting the waveform
* Setting the output frequency
* Setting the output amplitude and offset
3.13.2 Setting the Output
To set the output channel, press the Output ON key. The
key will lit indicating the output is enabled.
3.13.3 Using Voltage Offset
Through the offset parameter you can add a positive or
negative DC level to the output waveform.
To set voltage offset:
1. Select a waveform to display its menu.
2. Press F3:Offset to display the offset setting.
3. Use the rotary input knob or the numerical keys to set
the voltage offset.
To turn the voltage offset OFF, repeat the steps above,
but set the offset voltage level to 0.
3.13.4 Storing and Recalling a Waveform
Generator Setup
You can store front-panel setups inside the internal non-
volatile flash memory. When you recall a stored setup,
the front-panel settings change to match the settings in
the stored setup.