B&K Precision 4040B - Manual - Manual (Page 62)

62
Manufacturer name
Model name
Serial number (0 if not relevant)
Version number
Command
Type:
Common Query
Syntax: *IDN?
Response: BK, MODEL 4040B,0,V1.1
4.8.2 Internal Operation Commands
*RST - Reset command
The Reset command performs a device reset. It
causes the device to return to the factory default power up
state.
Type:
Common Command
Syntax: *RST
4.8.3 Device Trigger Commands
a) *TRG - Trigger command
This command is analogous to the IEEE 488.1 Group
Execute Trigger interface message, and has the same
effect. It is used to trigger the device to output a wave, and
is accepted only when the trigger mode is set to Trigger,
Gate or Burst, and the trigger source is set to BUS.