B&K Precision 4078 - Manual - Manual (Page 20)

 NBRST
o GATE
 MAN
 INT
•
GATE RATE
 EXT
o PHASE (not available in PULSE and ARB mode)
 PHASE
 SET-ZERO
 PREV
- SWEEP (not available in PULSE and ARB mode)
o ON | OFF
o START | STOP
o RATE
o LIN | LOG
- MODUL
o AM
 ON | OFF
 % | SHAPE
 MOD. FREQ
 EXT | INT
o FM (not available in PULSE and ARB mode)
 ON | OFF
 DEV | SHAPE
 MOD. FREQ
 EXT | INT
o FSK (not available in PULSE and ARB mode)
 ON | OFF
 F-HI | F-LO
 RATE
 EXT | INT
- UTIL
o RS232<
o RECALL | STORE
o POWER
3.6.1 WAVEFORM Keys
The keys select the waveform output and displays the waveform parameter menu (frequency, amplitude and offset).
When the Arbitrary waveform is selected, the display shows also the waveform rate.
Sine Menu
F1: FREQ - (Frequency) Selects and displays the frequency. Change the frequency setting using the cursor
keys and rotary knob or numerical keypad. If a certain wavelength can't produce the waveform at
the desired frequency, the waveform generator displays an “Out of Range” error message.
F1: FREQ/RATE - Selects and displays the Point Rate (for Arbitrary Waveform mode only). The Rate parameter
governs the rate at which waveform points are executed, and thus the frequency of the waveform
output will also be affected. When you set this parameter, the waveform generator will keep that
execution rate for all waveform lengths until it is changed.
F3: AMPL/OFST - Selects the Amplitude or the Offset parameters.