11 filling the thermodynamic dhw tank – DE DIETRICH KALIKO TWH 200E - TWH 300E - TWH 300EH User Manual
Page 44
*
Earth
L
Live
N
Neutral
P
Pressure switch
R1 - R6
Relay
S4
Evaporator sensor
S5
Room sensor
SPL1
Splice
TA
Impressed current anode
TS
Safety thermostat
X1
Connecting the impressed current anode
X2-S3
Bottom DHW temperature sensor
X3-S2
Middle DHW temperature sensor
X4-S1
Top DHW temperature sensor
X5
Room sensor, Evaporator, Pressure switch
X6
Control panel connection
X7
Hydraulic back-up command terminal board
X8
Command terminal board
X-B1
Electrical back-up command terminal board
X-HC
Pricing information input (HP-HC).
Allows authorisation of domestic hot water production
depending on the setting of the HP/HC input
4.11 Filling the thermodynamic DHW tank
1. Open a hot water tap.
2. Open the cold water tap located on the safety unit. Ensure that the
drainage valve on the unit is closed.
3. When the water overflows through the hot water tap, the appliance
is full. Close the hot water tap.
C
0
0
3
4
0
9
-A
4. Installation
TWH 200E TWH 300E TWH 300EH
42
03/02/2014 - 300026515-001-03