DE DIETRICH KALIKO TWH 200E - TWH 300E - TWH 300EH - Manual (Page 49)

Display Operating
mode
Description
M Automatic or
Comfort
Comfort programme activated
Domestic hot water production is handled by the heat pump and by electrical back-up if necessary
(+ Hydraulic back-up for EH version).
If domestic hot water production is not satisfied by the compressor after a modifiable time delay
(factory setting: 5 hours - Parameter P23), the back-ups start up.
% Eco Reduced programme activated .
Domestic hot water production is handled by the heat pump alone.
After the compressor stops, the displayed quantity of domestic hot water available may not be
complete (!).
W Boost Forced operating activated
Domestic hot water production is handled simultaneously by the heat pump and the electrical back-
up for a modifiable period (factory setting: 6 hours).
> days Vacation Holiday period
Shutting down domestic hot water production.
The domestic hot water temperature is kept at 10°C.
5.6 Reading out measured values
5.6.1. Measurements menu
1. Press once the MENU key. The SE nS 1 menu is displayed.
2. Press the MODEB key to go to the Measurements menu. The SE
01 menu is displayed.
3. Use the ( and ) keys to switch from one measurement to
another.
Parameters Description Unit
SE 01 Top DHW temperature sensor °C
SE 02 Middle DHW temperature sensor °C
SE 03 Bottom DHW temperature sensor °C
SE 04 Room sensor °C
SE 05 Evaporator temperature sensor °C
SE 06 Electricity tariff:
4
HP1: Peak hours
4
HC0: Off-peak hours
St Su Operating status / sub-status of the control system
sequence
SP 1 Back-up setpoint °C
SP 2 Compressor setpoint °C
5.6.2. Counters
n Displaying the counters
1. Press once the MENU key. The SE nS 1 menu is displayed.
C003206-D
1x
2x
3x
.
.
.
1 4
3 4
1 2
MENU MODE
TWH 200E TWH 300E TWH 300EH 5. Commissioning
03/02/2014 - 300026515-001-03 47