Hach-Lange AMTAX indoor sc - Manual (Page 27)

27
Installation
3.5.5 Connect the optional heated drain
CAUTION
The enclosure may tip forwards if it has not been fixed in
place. Only open the enclosure if the enclosure is properly
mounted.
DANGER
Disconnect power from the sc analyzer at the sc1000 before
removing the protective covers in the analyzer.
Refer to Figure 16 and the following procedure to connect the
heated drain.
1. Open the enclosure door and secure if necessary.
2. Open the analyzer panel.
3. Remove the protective cover ( Figure 14, page 24 ).
4. Connect the earth ground wire (green/yellow) to the ground
wire terminal strip.
5. Connect the cables for the heated drain (item 6, Figure 16,
page 28 ) to the terminal block (item 3, Figure 16, page 28 ).
6. Connect the drain tube as described in the appropriate Option
Configuration, refer to section A.5 , page 80 for more
information.
7. Place the drain tube to the appropriate drain or basin.
8. Install all covers and panels.