Hach-Lange AMTAX indoor sc - Manual (Page 80)

80
Plumbing and Connection Options
A.5 Option 1 plumbing and connections
Option 1 is used with an sc analyzer and the Filter Probe sc. The
waste from the analyzer is discharged back into the basin using the
Filtration Kit. Use the drain tube inside the Filter Probe sc or the
optional heated drain tube to discharge the waste stream from the
sc analyzer.
Refer to Figure 29 and the following instructions for Option 1:
1. Install the Filter Probe sc into the sample stream. Refer to the
Filter Probe sc User Manual for more information.
2. Feed the Filter Probe sc hose (sample lines, electrical cables
and drain tube) through the analyzer opening (item 5,
Figure 29 ). Use Seal Plug #2 to secure.
3. Seal the unused openings with Seal Plug #3.
4. Connect the Filter Probe sc data cable and power connections.
Refer to section 3.5.4, page 26 and Figure 16, page 28 .
5. Connect the air tube to the compressor (item 3). Refer to
section 3.5.5, page 27 .
6. Connect the drain tube to the Filter Probe sc ( Figure 29,
page 81 ).
7. Connect the sample line to the sample inlet on the overflow
vessel using the fittings.