6 information and warning windows, 7 instrument status indicator – Hach-Lange ORBISPHERE 6110 User Manual User Manual
Page 31
29
User Interface and Startup
4.1.6 Information and warning windows
At various stages, an information or warning message may be displayed to request confirmation
from the operator that his last action(s) must be applied, or that there is a problem that did not
enable the requested action to be performed.
Note:
Warning messages can be suppressed by unchecking the warning messages parameter (see
Instrument parameters on page 37
).
For a full list of all possible warning and error messages, and the recommended action to take,
please refer to the section entitled
4.1.7 Instrument status indicator
A colored LED indicator on the top right of the screen will indicate the current status of the
system:
•
A green indicator means that no problems have been found
•
A yellow indicator means that a problem has been found, but is not serious enough to stop
measurements being taken
•
A red indicator means that there is a serious problem with the system which must be
corrected before any measurements can be performed
If multiple problems have been detected, the color of the LED will reflect the most severe error
(red in the example below). If the LED indicator is not green, pressing it on any screen will
display a list of errors and warnings:
It is advisable to correct all of the errors listed before continuing, to ensure the instrument is
working correctly.
On completion of all startup checks you may be required to enter a valid identification number
and password (as described in
User identification and access level on page 31
) to continue.
Provided all startup checks were successful, the measurement screen will be displayed.