Hach-Lange RTC113 ST-Module - Manual (Page 21)

21
Section 4 Parameterization and operation
4.1 Operating the sc controller
The RTC Module can only be operated via the sc1000 controller
in conjunction with the RTC communication card. Before the RTC
Module is used, the user must be familiar with the functionality of
the sc1000 controller. Learn how to navigate through the menu
and perform the relevant functions.
4.2 sc1000 setup
1. Open the MAIN MENU .
2. Select RTC MODULES / PROGNOSYS and confirm.
3. Select RTC MODULES and confirm.
4. Select RTC and confirm.
4.3 Menu structure
Note: Refer to Section 6 Troubleshooting, page 37 for a list of all
possible error and warning messages together with a description of all
necessary countermeasures to be taken.
4.4 Configuration of RTC113 ST-Module parameters on the sc1000 controller
The following menu items are in the SC1000 SETUP menu.
4.3.1 DIAGNOSIS
DIAGNOSIS
RTC
ERROR LIST
Possible error messages:
RTC MISSING, RTC CRC, CHECK CONFIG, RTC FAILURE
WARNING LIST
Possible warning messages:
MODBUS ADDRESS, PROBE SERVICE
REMINDER LIST
4.4.1 RTC113 ST-Module open and closed-loop controller
RTC MODULES / PROGNOSYS
RTC MODULES
RTC
CONFIGURE
SELECT SENSOR
Select the sensors installed for the open/closed-loop controller
(refer to section 4.5, page 26 ).