Hach-Lange RTC113 ST-Module - Manual (Page 26)

26
Parameterization and operation
4.5 Select sensors
1. To select sensors and their sequence for the RTC Module,
press RTC > CONFIGURE > SELECT SENSOR.
Figure 6 Select sensor
2. Press ADD ( Figure 6 , item 3).
A selection list of all subscribers to the sc1000 network
opens.
3. Press the required sensor for the RTC Module and confirm
by pressing ENTER below the selection list.
Sensors in black type are available for the RTC Module.
Sensors in red type are not available for the RTC Module.
Note: Sensors marked (p) are available for PROGNOSYS if these
sensors have been selected in conjunction with an RTC (refer to the
PROGNOSYS user manual).
1 ENTER — Saves the setting and returns to the
CONFIGURE menu.
4 DELETE — Removes a sensor from the selection.
2 CANCEL — Returns to the CONFIGURE menu without
saving.
5 UP/DOWN — Moves the sensors up or down.
3 ADD — Adds a new sensor to the selection.