Hach-Lange RTC113 ST-Module - Manual (Page 27)

27
Parameterization and operation
4. The selected sensor is shown in the sensor list.
Press ADD ( Figure 6 , item 3) to open the selection list again.
5. Select the second sensor for the RTC Module and confirm
by pressing ENTER below the selection list.
Note: Previously selected sensors are shown in gray.
The selected sensors are shown in the sensor list.
6. To sort the sensors in the order specified for the RTC
Module, press the sensor and use the arrow keys to move it
( Figure 6 , item 5).
Press DELETE ( Figure 6 , item 4) to remove an incorrect
sensor from the sensor list again.
7. Press ENTER ( Figure 6 , item 1) to confirm the list once it is
finished.