Adaptec 48300 - Manual (Page 33)

Installing the Driver ●
33
Installing the Driver in an Existing Windows System
To install the driver in an existing operating system:
1 Install and configure the HostRAID controller and disk drives, as
described in
Installing the HostRAID Controller and Drives on
page 24 .
2 Create the driver disk, as described on Creating the Driver Disk on
page 31 . When finished, remove the driver disk.
3 Start Windows. Windows launches the Found New Hardware
Wizard, which searches for the driver.
4 Insert the driver floppy disk, select the floppy disk drive as the
source, then click Next.
5 Click Next in the two subsequent windows and follow the on-screen
instructions to complete the driver installation.
6 Remove the driver disk and restart the computer.