Adaptec 48300 - Manual (Page 65)

Adaptec Flash Utility (AFU) ●
65
● /D <UFI File Path> specifies the path (drive and directory) where
the UFI files are located. If you do not specify the /D switch, the AFU
looks for, or creates, UFI files in the default location.
Note: You cannot specify the name of a UFI file, only its path. UFI
filenames are predefined, based on the HostRAID controller type.
Examples
In the following example, the AFU saves flash contents from HostRAID
controller 0 to a UFI file in the current default drive and directory:
A:\> AFU SAVE /C 0
In the following example, the AFU saves flash contents from Controller
1 to a UFI file in
C:\UFI_FILES .
A:\> AFU SAVE /C 1 /D C:\UFI_FILES
UPDATE
The UPDATE command updates a HostRAID controller’s flash
components from the flash image data in a UFI file. You can use the
UPDATE command to update a single HostRAID controller’s flash
components or to update multiple HostRAID controllers on your
computer.
You must restart the computer following an UPDATE command.
Command Syntax
The command syntax for the UPDATE command is as follows:
AFU UPDATE [/C<Controller ID>] [/D <UFI File Path>]
Command Switches
For details on the /C and /D switches, see the SAVE command on page 64 .