Verify – Adaptec 48300 User Manual
Page 66
Adaptec Flash Utility (AFU)
●
66
Examples
The following example shows a typical system response after an update
has been performed:
A:\> AFU UPDATE /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Updating Controller 0 (Adaptec ASC-48300)
Reading flash image file (Build 1406)
AFU is about to update firmware on controller(s) Adaptec ASC-48300
***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE***
This might take a few minutes.
Writing Adaptec ASC-48300 (4MB) Flash Image to controller 0...OK.
Verifying...OK
Please restart the computer to allow firmware changes to take effect.
VERIFY
The VERIFY command compares the contents of each of the flash
components on a HostRAID controller to the corresponding image in a
UFI file and indicates whether they match. Use this command to
determine whether a HostRAID controller’s flash components are up-
to-date when compared to a specific UFI file.
Command Syntax
The command syntax for the VERIFY command is as follows:
AFU VERIFY [/C<Controller ID>] [/D <UFI File Path>]
Command Switches
For details on the /C and /D switches, see the
.