Adaptec 48300 - Manual (Page 57)

Using the Adaptec RAID Configuration Utility ●
57
CTRL-A Message
Display Enabled
Disabled When set to Enabled, the SAS
HostRAID controller BIOS
displays the Press <Ctrl> <A>
for Adaptec RAID
Configuration Utility message
on your screen during system
bootup. If this setting is
disabled, you can still invoke
the Adaptec RAID
Configuration utility by
pressing Ctrl+A after the SAS
card BIOS banner appears.
Physical Drives Display
during Post Enabled
Disabled When Enabled, attached
physical devices are displayed
during system POST.
Displaying the devices adds a
few seconds to the overall
POST time.
PHY Configuration
PHY Rate Auto, 1.5, 3.0 The data transfer rate between
the
HostRAID controller and
devices. The default setting is
Automatic, which allows the
SAS card to adjust the speed as
needed.
Note: SATA-II targets are
negotiated at 1.5 Gbps only.
SAS Address 0-F Specifies the last digit of a 64-
bit SAS address of the
HostRAID controller, device,
and each port using a globally
unique worldwide name
(WWN) identifier.
Controller Properties
PCI Slot: Bus:
Device:Function None Displays the path of the
storage devices in a Host RAID
controller.
Interrupt (IRQ)
Channel None Displays interrupt
SerialSelect Options
Available
Settings
Description