Adaptec 48300 - Manual (Page 79)

Using the Command Line Utility ●
79
Syntax
hrconf setstate <Controller#> <Channel#>
<Device#> <State> [LOGICALDRIVE <LD#>[LD#] ... ]
Parameters
Controller# is the controller number
channel# is the channel number for the drive
device# is the device number for the drive
State:
● HSP : Create a hot spare from a ready drive
● RDY : Remove a hot spare designation
● DDD : Force a drive offline
Example
hrconf setstate 1 0 1 HSP
hrconf setstate 1 0 2 RDY
hrconf setstate 1 0 2 RBL
Return values
SUCCESS: 0x00 indicates the command completed successfully
FAILURE: 0x01 indicates the command failed