Ransburg Aerobell 168 A12787 - Manual (Page 12)

Aerobell 168 - Introduction
9 LN-9270-12.3
OPERATING CHARACTERISTICS AND SPECIFICATIONS
Weight
Atomizer (Post Mount 65mm): 2.7 kg (6 lbs.)
Atomizer (Robot Mount /Valves/65mm): 4.4 kg (9.7 lbs.)
Voltage
Maximum Operating Voltage: 100 kV
Maximum Operating Current: 200 uA
Turbine
Recommended Turbine Speed: 15 to 60 Krpm
Turbine Type: Impulse – Rear Exhaust
Speed Readout Pickup: Magnetic of Light Source (2 Pulse/Rev.)
Paint
Flow Rate: 50-500 cm 3
/min max. (depending on paint)
Normal Supply Pressure: 6 - 8 bar (90 psi - 120 psi)
Maximum Pressure: 10 bar (150 psi)
Viscosity: 20 to 40 Seconds – Ford Cup # 4
Viscosity: 20 to 45 Seconds – AFNOR Cup #4
Paint Resistivity: >1 MOhm.cm
Air Pressure
Microvalve Pilot: 4.9 bar (Min.) – 10 bar (Max.) (75 – 150 psi)
Bearing Air: 5.5 bar (Min.) – 7 bar (Max.) (80 – 100 psi)
Shaping Air: 7 bar (Max.) (100 psi Max.)
Brake Air: 4 bar (Min.) – 7 bar (Max.) (60 – 100 psi)
Change Time
Rotator Atomizer: Less than 5 minutes
Bell: Less than 5 minutes
Distance:
Target: 152 – 305mm (5 – 12 inches)
Compressed Air Quality See Filter Section
Air Consumption
Bearing Air: 57 – 85 slpm (2 – 3 scfm)
Shaping Air 1: 75 to 600 NI/min (2.65 – 21.2 scfm)
Shaping Air 2: 75 to 600 NI/min (2.65 – 21.2 scfm)
Turbine See Charts
Bell Cups
15mm: 100 cc/min. (max.)
30mm: 300cc/min. (Max.)
65mm: 500 cc/min. (Max.)