Ransburg Aerobell 168 A12787 - Manual (Page 67)

Aerobell 168 - Maintenance
LN-9270-12.3 64
MAINTENANCE DISASSEMBLY PROCEDURES
(30mm Bell Cup and Shape Air Ring)
Step 5
Remove Shape Air Ring.
Pull straight off.
Note: The Shape Air Ring
is sealed with a O-ring and
may be difficult to remove.
Note: When reassembling
an audible “Click” should
be heard.
Step 6
Note: The Shape Air Ring has a
blue alignment mark . The blue
alignment mark will line up with
the yellow dot located on the At-
omizer Body and the small yellow
line located on the Turbine. All
three (3) alignment marks will
have to be in line when assem-
bling.
Step 7
Note: Two (2) locating pins are
mounted on the back of the
Shape Air Ring to insure proper
alignment.
Y
E
LL
O
W
D
O
T
YE
LL
OW
LI
NE
BLUE
LINE