Ransburg Aerobell 168 A12787 - Manual (Page 74)

Aerobell 168 - Maintenance
71 LN-9270-12.3
MAINTENANCE DISASSEMBLY PROCEDURES
(65mm Bell Cup and Shape Air Ring)
Step 7
Remove Shape Air Ring. Pull
straight off.
Note: The Shape Air Ring is
sealed with a O-ring and may
be difficult to remove.
Note: When reassembling an
audible “Click” should be
heard.
Step 8
Note: The Shape Air Ring has
a blue alignment mark . The
blue alignment mark will line
up with the yellow dot located
on the Atomizer Body and the
small yellow line located on
the Turbine. All three (3)
alignment marks will have to
be in line when assembling.
Step 9
Note: Two (2) locating pins
are mounted on the back of
the Shape Air Ring to insure
proper alignment.
YE
LL
OW
D
OT
YELLOW LINE
BLU
E LIN
E