Ransburg Aerobell 168 A12787 - Manual (Page 31)

Aerobell 168 - Installation
LN-9270-12.3 28
Ransburg Filter
Model No. Description / Specifications Replacement Ele-
ment Part No.
HAF-503 Pre-filter, removes coarse amounts of oil, moisture
and dirt. Used upstream of HAF-508 pre-filter
(used in systems with poor air quality. HAF-15 Element One
HAF-508 Pre-filter, coalescing type, 136 SCFM, 98.5% effi-
ciency particulate removal .3 to .6 micron, max.
aerosol passed 1.0 micron, max. solid passed .4
micron (dependent upon SCFM requirement per
applicator, one HAF-508 can be used with up to
three Aerobell 168 assemblies). HAF-38 Elements,
Carton of 4
RPM-418 Bearing air filter, coalescing type,19 SCFM,
99.995% efficiency particulate removal .3 to .6 mi-
cron, max. Aerobell 168 passed .6 micron max.
solid passed .2 micron (one per Aerobell 168
)
RPM-33 Elements,
Carton of 8
AIR FILTRATION REQUIREMENTS
Air must be properly filtered to ensure ex-
tended turbine life and to prevent contamina-
tion of the paint finish. Air which is not ade-
quately filtered will foul the turbine air bearings
and cause turbine failure. The correct type fil-
ters musts be used in an Aerobell 168 system.
The filter elements must be replaced regular
schedule to assure clean air.
It is the user’s responsibility to ensure clean
air at all times. Turbine failure resulting form
contaminated air will not be covered under
warranty. If other filters are incorporated in the
system, the filters to be used must have filter-
ing capacities equal or better than those
shown in “Air Filtration Requirements Charts.”
The user must ensure the bearing air supply
is not inadvertently turned off while the Aero-
bell 168 air motor is turning. This will cause air
bearing failure.
Each applicator must have its own filter for
bearing air. Recommended: RPM-418 or
equivalent.
N O T E ! C A U T I O N