Ransburg Aerobell 168 A12787 - Manual (Page 84)

Aerobell 168 - Maintenance
81 LN-9270-12.3
MAINTENANCE DISASSEMBLY PROCEDURES
(For Robot/Machine Mount Kits)
Remove the Internal Cup Wash
Fitting from the Rear Manifold .
When assembling the Internal
Cup Wash Fitting, tighten with
fingers until an audible “click” is
heard.
Note: Be careful not to drop the
Cup Wash Ferrule.
Make sure when assembling the
Internal Cup Wash Fitting that
the ferrule taper end is inserted
into the Internal Cup Wash Fit-
ting.
Step 3
Step 4
Remove the Cup Wash Fittings
from the “Y” Fitting mounted on
the Valve Manifold.
Note: Please refer to pages 52
& 53 (58 & 59) steps 1 through
4 for procedures on removal of
the Cup Wash Fitting that is
mounted on the Shape Air
Ring with the 30 mm (65mm)
Bell Cup.