Ransburg Evolver Solvent Applicator 79190-XXXXXXXX - Manual (Page 22)

17
Evolver Solventborne Robotic Atomizers - Installation
GUN AND MANIFOLD
ASSEMBLY
(See Figures 4 and 5)
The tubing, hose, and low voltage cable come bundled
from the factory. Pull the bundle through the robot
spacer plate and robot wrist carefully to prevent any
cuts on the cable or hoses. Use the six (6) socket head
cap screws (7959-32C) included with the rear manifold
tubing assembly to attach the rear manifold assembly
( 79156) to the robot spacer plate (see Table 1).
Connect each signal line as required per signal legend
for both English and Metric tubing bundles, table
following.
Robot Spacer Plate
The robot spacer plate is included with the robot
manifold assembly to increase life of the tubing
bundle. The extra spacing it provides, increases the
bend radius of the tubes and decreases the hose or
cable stress at the connector.
There is only one way the spacer plate may be as-
sembled to the mounting plate. The spacer plate has
an alignment pin that may only engage in one hole
position in the robot mount plate. This provides the
final position to top dead center of the robot.
The six (6) robot spacer plates, Table 1, are available
for this product.
> Do not exceed 100' combined length of the
low voltage cables.
C A U T I O N
!
79107-00 ABB Robots
78983-00 Fanuc P155, 145 Robots
79131-00 Fanuc P200 Robot
A10847-00 Adapter (Kawasaki-KE610L)
A10848-00 Adapter (Motoman-PX2850)
A10849-00 Adapter (Motoman-PX2900)
Part # Description
TABLE 1 - SPACER PLATES
> Leave 12-24 inches of extra length on all lines
to prevent extreme tension being applied to these
lines during robot movement.
C A U T I O N
!
> Install and route the hoses and cable so that
they are NOT exposed to temperatures in excess
of 120 ° F. Ensure that all hose and cable bends
are NOT LESS THAN a 6 inch (15cm) radius and
are not subjected to more than 360 ° of torsional
twist. Failure to comply with these parameters
could cause equipment malfunctions that might
create HAZARDOUS CONDITIONS!
W A R N I N G
!
> If a non-explosion proof junction box/termi-
nal strip is used, it must be located outside the
hazardous area.
W A R N I N G
!
For installations utilizing the LECU5004-XX Mi-
croPak Power Supply, connect the low voltage cable
(79008-XX) from the robot manifold assembly to the
LECU5004-XX MicroPak Controller or junction box.
If connecting to a junction box, use a junction cable
(77062-XX) to make the connection from the junction
box to the LECU5004-XX MicroPak. Make connections
as shown in Figure 4.
For installations utilizing the A10406-XX Evolver Mi-
croPak Power Supply, connect the low voltage cable
(A11353-XX or A11356-XX) from the robot manifold
assembly or junction box to the receptacle on the
rear of the A10406-XX power supply. To maintain
FM Approval, this cable must be secured to the
stress relief bar on the rear of the power supply. (See
"A10406-XX Evolver
MicroPak Power Supply" manual for further informa-
tion on connecting the low voltage cable.)
AA-03-02.11