TREND NX Variable Speed Drives - Manual (Page 31)

14 • vacon RECEIPT OF DELIVERY
Tel. +358 (0)201 2121 • Fax +358 (0)201 212 205
3
3. RECEIPT OF DELIVERY
Vacon NX frequency converters have undergone scrupulous tests and quality checks at the factory before
they are delivered to the customer. However, after unpacking the product, check that no signs of transport
damages are to be found on the product and that the delivery is complete (compare the type designation of
the product to the code below, Figure 3-1.
Should the drive have been damaged during the shipping, please contact primarily the cargo insurance
company or the carrier.
If the delivery does not correspond to your order, contact the supplier immediately.
In the small plastic bag included in the delivery you will find a silver
Drive modified sticker. The purpose of
the sticker is to notify the service personnel about the modifications made in the frequency converter.
Attach the sticker on the side of the frequency converter to avoid losing it. Should the frequency converter
be later modified (option board added, IP or EMC protection level changed), mark the change in the sticker.
3.1
Type designation code
Figure 3-1. Vacon NX type designation code
NXS 0000 A 2 H 1 SSV A1A20000C3 5
Product range: NXS = standard, NXP = high-performance
Nominal current (low overload)
0007 = 7 A, 0022 = 22 A, 0205 = 205 A etc.
Nominal mains voltage (3-phase):
2 = 208–240Vac, 5 = 380–500Vac, 6 = 525–690Vac (All 3-phase)
Control keypad:
A = standard (alpha-numeric)
B = no local control keypad
F = dummy keypad
G = graphic display
Enclosure class:
0 = IP00 (FR9 only), 2 = IP21/NEMA 1, 3 = IP21/NEMA 1 (cabinet-mounted)
5 = IP54 (NEMA 12), 7 = IP54/NEMA 12
EMC emission level:
C = fulfils standard EN61800-3+A11, 1st environment (unrestr.)
H = fulfils standard EN61800-3+A11, 1st environment
restricted distribution, 2nd environment
L = fulfils standard EN61800-3+A11, 2nd environment, restr. distr.
T = fulfils standard EN61800-3 for IT networks
N = No EMC emission protection
Brake chopper
0 = no brake chopper
1 = internal brake chopper
2 = internal brake chopper and resistor
Option boards; each slot is represented by two characters where:
A = basic I/O board, B = expander I/O board,
C = fieldbus board, D = special board
Hardware modifications; Supply - Mounting - Boards
Sxx = 6-pulse connection (FR4 to FR14)
Bxx = Additional DC-connection (>FR8)
Jxx = FR10...12 stand-alone with main switch and DC-link terminals
xSx = Air-cooled drive
xxS = Standard boards (FR4 to FR8)
xxV = Varnished boards (FR4 to FR8)
xxF = Standard boards (FR9 to FR14)
xxG = Varnished boards (FR9 to FR14)
xxA = Standard boards (FR10 to FR12 standalone drives)
xxB = Varnished boards (FR10 to FR12 standalone drives)
Note: Ask factory for other possible installation combinations.