XLT XD-9010B - Manual (Page 2)

2
WARNING & SAFETY INFORMATION
 Post in a prominent location instructions to be followed in the event you smell gas. This infor-
mation can be obtained by consulting your local gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable
liquids or vapors in the vicinity of this or any other appliance.
Improper installation, adjustment, alteration, service or maintenance can cause prop-
erty damage, injury, or death. Read the installation, operating and maintenance in-
structions thoroughly before installing, using, or servicing this equipment.
 In the event a gas odor is detected, shut off the gas at the main shutoff valve immediately.
Contact your local Gas Company or supplier.
 Do not restrict the flow of combustion and/or ventilation air to the unit. Provide adequate
clearance for operating, cleaning, and maintaining the unit and adequate clearance for operat-
ing the gas shutoff valve when the unit is in the installed position.
 Keep the area free and clear of combustible material. DO NOT SPRAY AEROSOLS IN THE
VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.
 Ovens are certified for installation on combustible floors.
 Electrical schematics are located inside the control box of the oven and at the end of this man-
ual. Disconnect input power to the unit before performing any maintenance.
 This unit requires a Type I ventilation hood, which requires make-up and exhaust air to ensure
adequate air supply. The installation should conform to local codes.
 This unit may be operated with either natural gas or LP fuel as designated on the nameplate
label located on the side of the unit.
 This unit must be operated by the same voltage, phase, and frequency of electrical power as
designated on the nameplate label located on the side of the unit.
 Minimum clearances must be maintained from combustible and non-combustible construction
materials.
 Follow all local codes when installing this unit.
 Follow all local codes to electrically ground the unit.
 Appliance is not to be cleaned with high pressure water.
 Ovens are certified for use in stacks of up to three (3) units of XLT products. Integration of
other manufacturer’s products into an oven stack is not recommended, and will void any war-
ranties. XLT Ovens assumes no liability for mixed product applications.
 PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
SAFETY DEPENDS ON YOU
WARNING
WARNING