XLT XD-9010B - Manual (Page 23)

23
Oven Installation
Physical Location & Spacing Requirements
XLT Ovens are suitable for installation on either combustible or non-combustible floors,
and adjacent to either combustible or non-combustible walls. The motor cover is designed to pro-
vide the proper clearance to the back of the oven. The minimum side clearances are 6in. / 150mm,
measured from the end of the conveyor.
Electric Supply Requirements for Australian, Standard. & World Ovens
 In Australia, the electrical service must be installed in accordance with the latest
version of AS/NZS 3000 wiring rules.
Australian Ovens
 When installed, the appliance must be electrically grounded in accordance with
local codes, or in the absence of local codes, with the National Electrical Code,
ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.2, as applicable.
Electrical Grounding Instructions
This appliance is equipped with a three-prong (grounding) plug for your pro-
tection against shock hazard and should be plugged into a properly grounded
three-prong receptacle. Do not cut or remove the grounding prong from this
plug
.
Standard Ovens
World Ovens
 This appliance is equipped with a ground lug for your protection against shock
hazard and must be properly grounded.
 When installed, the appliance must be electrically grounded in accordance with
local codes.
HIGH
VOLTAGE
CAUTION
All installations must conform to local building and mechanical codes.
NOTE