Stacking hood on the ovens hood installation – XLT XD-9010B User Manual
Page 75
75
1. Fully insert the lifting jacks into the lifting gear assemblies attached to each end of the hood.
2. Raise the hood high enough to clear the cart or skid.
Failure to engage properly can result in damage, injury, or death from a falling
Hood.
WARNING
Both jacks should be raised in unison, otherwise they may bind and a dangerous
situation may develop.
Do not put any part of yourself under the hood at any time.
The hood is top heavy. Be careful!
WARNING
3. Remove the cart or skid.
4. Rotate the hood as shown.
5. Raise the hood high enough to clear top oven.
6. Roll the oven stack underneath the hood.
7. Lower the hood onto the ovens lining up the two (2) front screw holes in the inside filler panels
with the screw holes on oven lid.
8. Reinsert screws saved from previous step.
9. Remove lifting jacks and lifting gear from ends of hood
10. Move oven/hood stack into position.
Stacking Hood on the Ovens
Hood Installation
Lifting Gear
Reinsert screws
Lifting Jack
NOTE
Switches MUST face front of ovens.
Front of Ovens
Switches