XLT XD-9010B - Manual (Page 20)

20
Lifting Jack Setup
Each lifting jack consists of two (2) parts; the pole/winch assembly, and the tripod base.
Oven Assembly
Lifting Pipe
Top of Oven
Jack
Cart
Bands
Front of Oven
2. Insert the lifting pipe through the oven bake chamber. Make sure the pipe is centered.
 Make sure that the notch on tube of the winch assembly is aligned with the pin
in the tripod base as shown. These alignments are important and keep the jack
aligned properly.
 Check for smooth operation. The cable should not be pinched and should pass
smoothly over the pulley on top of the pole assembly.
 Inspect cable prior to each use.
 If cable is frayed or shows signs of excessive wear and tear, DO NO USE until
cable is replaced.
 At a minimum replace the cable annually with wire rope that meets or exceeds
the jack manufacturer’s specifications.
 Do not exceed the stated capacity of the jack.
WARNING
1. Place the bottom of the pole into the socket of the tripod base.
Illustrations shown with XLT Oven on Cart, instructions also apply when oven is crate shipped.