XLT XD-9010B - Manual (Page 73)

73
Hood Installation
Lifting Gear Setup
Threaded Rod
End Beam
Saddle
Lifting Hook
Bracket
Nuts
Locking Pin
1. Insert end of each threaded rod into the small holes located on bracket so that ends are to the inside of bracket.
2. Thread nuts about 1/2” (12.7mm) onto threaded rod ends.
3. Slide saddle pin through appropriate hole located on End Beam, see placement diagram above.
4. Slide bracket and lifting hook assembly onto saddle pin with bracket resting flat on end beam.
5. Insert locking pin in hole located near end of saddle pin.
6. Place lifting gear assembly against end of hood with saddle pads against vertical surface.
7. Insert each lifting hook into notch located at corner of fascia end.
8. Tighten nuts on threaded rods until End Beam can not be moved.
Left end shown, right end similar
End Beam
Saddle placement
18xx
24xx 38xx
32xx 18xx
24xx 38xx
32xx