Hood installation lifting jack setup – XLT XD-9010B User Manual
Page 74
74
Hood Installation
Lifting Jack Setup
Each lifting jack consists of three (3) parts; the pole/winch assembly, extension tube, and tripod
base.
Check for smooth operation. The cable should not be pinched and should pass
smoothly over the pulley on top of the pole assembly.
Inspect cable prior to each use.
If cable is frayed or shows signs of excessive wear and tear, DO NO USE until
cable is replaced.
At a minimum replace the cable annually with wire rope that meets or exceeds
the jack manufacturer’s specifications.
Do not exceed the stated capacity of the jack.
WARNING
1. Place the smaller end of extension tube into tripod base.
2. Place bottom of the pole into the top of the extension tube and tighten knob.
Pole/Winch Assembly
Extension Tube
Tripod Base
Back of Hood
Bottom of Hood
Cart
Lifting Gear
Illustrations shown with AVI hood on cart, same instructions apply when hood is crate shipped.