IEI Integration WAFER-945GSE2 v1.03 - Manual (Page 80)

WAFER-945GSE2 User Manual
Page 63
Jumper Label: ATXCTl1
Jumper Type: 3-pin header
Jumper Settings: See Table 5-2
Jumper Location: See Figure 5-3
The AT/ATX Power Select jumper specifies the systems power mode as AT or ATX. Use a
jumper cap to short pin 1 - pin 2 on the ATXCTL1 connector to enable the AT Power mode
on the system. In the ATX mode use the PS_ON- and 5VSB cable. AT/ATX Power Select
jumper settings are shown in Table 5-2.
AT Power Select Description
Short 2 – 3 Use AT power Default
OFF Use ATX power
Table 5-2: AT/ATX Power Select Jumper Settings
The location of the AT Power Select jumper is shown in Figure 5-3 below.
Figure 5-3: AT/ATX Power Select Jumper Location