IEI Integration WAFER-945GSE2 v1.03 - Manual (Page 87)

WAFER-945GSE2 User Manual
Page 70
SATA power cable
5.6.2 SATA Drive Connection
The WAFER-945GSE2 is shipped with two SATA drive cables. To connect the SATA
drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See
8
Figure 5-8.
Figure 5-8: SATA Drive Cable Connection
Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See
8
Figure 5-9.