IEI Integration WAFER-945GSE2 v1.03 - Manual (Page 88)

WAFER-945GSE2 User Manual
Page 71
NOTE:
The SATA power cable described below is an optional item and must
be pre-ordered. The SATA power cable is not shipped with the system.
Step 4: Connect the SATA power cable. Connect the SATA power connector to the
back of the SATA drive. See
8
Figure 5-9. Step 0:
Figure 5-9: SATA Power Drive Connection
5.6.3 Dual RS-232 Cable Connection (w/o bracket) (Optional)
The dual RS-232 cable consists of two connectors attached to two independent cables.
Each cable is then attached to a D-sub 9-pin male connector. To install the dual RS-232
cable, please follow the steps below.
Step 1: Locate the connectors. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 2: Insert the cable connectors. Insert one connector into each serial port box
headers. See Figure 5-10. A key on the front of the cable connectors ensures