IEI Integration WAFER-945GSE2 v1.03 - Manual (Page 81)

WAFER-945GSE2 User Manual
Page 64
5.4.2 CF Card Setup
Jumper Label: JCF1
Jumper Type: 2-pin header
Jumper Settings: See Table 5-3
Jumper Location: See Figure 5-4
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in Table 5-3.
CF Card Setup Description
OFF Slave Default
Short 1-2 Master
Table 5-3: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in Figure 5-4.
Figure 5-4: CF Card Setup Jumper Location
5.4.3 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header
Jumper Settings: See
8
Table 5-4
Jumper Location: See
8
Figure 5-5