IEI Integration WAFER-945GSE2 v1.03 - Manual (Page 92)

WAFER-945GSE2 User Manual
Page 75
Step 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 2: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 5-13.
Figure 5-13: Audio Kit Cable Connection
Step 3: Connect the audio devices. Connect one speaker to the line-in audio jack, one
speaker to the line-out audio jack and a microphone to the mic-in audio jack.
5.6.6 PC/104 Module Installation
The WAFER-945GSE2 has a standard PC/104 connector. To install a PC/104 module
please refer to and follow the installation instructions and diagram below: