Output specifications (source type) – Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 158
Chapter 5 DIO Connector
5-5
Output Specifications (Source type)
Output Circuit (Source type)
Rated Voltage
DC 24V
Rated Voltage Range
DC 20.4V to DC 28.8V
Output Method
Source Output
Maximum Load Voltage
0.2A /point, 0.4A /common
Output Voltage Drop
DC 1.5V or less
Output Delay Time
OFF to ON: 1ms or less
ON to OFF: 1 ms or less
Voltage Leakage (when OFF)
0.1mA or less
Clamp Voltage
39V ±1V
Type of Output
Transistor Output
Common Lines
1
Common Design
2 points/1 common line
External Connection
12-pin connector (also used for Input)
Output Protection Type
Output is unprotected
Internal Fuse
1.5A, 125V DIP fuse (not replaceable)
Surge Control Circuit
Zener diode
Output Points
2
Output Signal Display
No LED indicators
Status Display Element
None
Isolation Method
Photocoupler Isolation
External Power Supply
DC 24V
•
Since the output terminals are not electrically protected, an output line might be short-circuited
or a connection fault might damage the GP unit. Please install an applicable fuse to prevent an
overload in the circuit, if necessary.
L
L
Internal Circuit
Internal Circuit
+24V B1
OUT0 B2
OUT1 A2
0V A1
Fuse 1.5A
DC 24V
External Power
+
-