Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 177
Advertising
GP3000 Series Hardware Manual
8-6
(3)
Insert each of the fasteners shown below.
Be sure to pull the fastener back until it is
flush with the rear of the attachment hole.
(4)
Use a Phillips screwdriver to tighten each
fastener screw and secure the GP in place.
• Tightening the screws with too much force can damage the GP unit’s plastic case.
• The torque required to tighten these screws is 0.5 N•m.
Advertising
This manual is related to the following products: