Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 54)

Chapter 3 Part Names and Functions
3-9
O: Ethernet Interface (LAN)
The Ethernet transmission interface (10BASE-T/
100BASE-TX). An RJ-45 type modular jack
connector (8-pole) is used. The LED turns on or off
to indicate the current status.
P: USB Host Interface (USB)
Complies with USB 1.1. Uses a “ TYPE-A” connector. Power supply voltage: 5VDC
±
5%, Output current:
500mA(max). The maximum communication distance : 5m.
Q: CF Card Cover
The CF Card I/F and Dip Switches are located in the CF Card Cover open. This cover must be closed when
accessing the CF Card.
R: Dip Switches
LED Indicates
Green ON Data transmission available
Green OFF
No connection or
subsequent transmission
failure
Yellow ON
Data transmission is
occurring.
Yellow OFF No data transmission
Dip
Switches
Function ON OFF Note
1
CF Card Startup Settings
(Controls unit startup from
the CF Card.)
Startup from CF
Card is enabled.
Startup from CF
Card is
disabled. CF Card with
startup data
required.
2
*1
*1 When power supply is turned ON at dip switch 2 is ON, it starts with Transfer Mode. Usually,
use it in OFF.
Forced Transfer Mode
Forced Transfer
Mode: ON Forced Transfer
Mode: OFF
-
3 Booking - - Constantly OFF
4
This setting controls the
forced closing of the CF
Card cover.
Forced close
enabled. Forced close
disabled.
Used when CF
Card cover is
damaged.
O P
Q
R
Bottom
(With CF Card Cover open)
1 2 3 4
ON