AMT Datasouth ACCEL-6300 - Manual (Page 113)

User's Guide
5-6 Cleaning and Maintenance
Cleaning Printer Surfaces
To keep your printer looking new, you
should periodically clean its surfaces with
glass cleaner (Windex
® or equivalent), 91%
isopropyl alcohol, or a mild dishwashing
detergent (Lux
® or equivalent).
To clean the printer surfaces, use the
following procedure:
1. Turn off the printer and detach the
power cord.
2. Using a soft brush or lint-free cloth, dust
all of the exterior surfaces, as shown in
figure 5-6. Be sure the cloth is free of
grit or other matter.
3. Using a cloth lightly moistened with glass
cleaner, 91% isopropyl alcohol, or a mild
dishwashing detergent, wipe and clean
the platen window.
4. Raise the top cover. Using a soft brush
or vacuum, remove all paper fibers, dust
and foreign matter from inside the
printer. Then, lower the top cover.
5. Using a soft brush or vacuum, remove
all paper fibers, dust, and foreign matter
from the rear forms tractors, as shown
in figure 5-7.
6. Re-attach the power cord and turn on
the printer. Then, run a printer self test
to verify normal operation.
Figure 5-6. Cleaning Printer Surfaces
Figure 5-7. Cleaning the Forms Tractors
BRUSH OR VACUUM
CARRIAGE PATH
WIPE SURFACES WITH
MILD DETERGENT
BRUSH OR VACUUM
FORMS TRACTORS
User's Guide
5-6 Cleaning and Maintenance
Cleaning Printer Surfaces
To keep your printer looking new, you
should periodically clean its surfaces with
glass cleaner (Windex
® or equivalent), 91%
isopropyl alcohol, or a mild dishwashing
detergent (Lux
® or equivalent).
To clean the printer surfaces, use the
following procedure:
1. Turn off the printer and detach the
power cord.
2. Using a soft brush or lint-free cloth, dust
all of the exterior surfaces, as shown in
figure 5-6. Be sure the cloth is free of
grit or other matter.
3. Using a cloth lightly moistened with glass
cleaner, 91% isopropyl alcohol, or a mild
dishwashing detergent, wipe and clean
the platen window.
4. Raise the top cover. Using a soft brush
or vacuum, remove all paper fibers, dust
and foreign matter from inside the
printer. Then, lower the top cover.
5. Using a soft brush or vacuum, remove
all paper fibers, dust, and foreign matter
from the rear forms tractors, as shown
in figure 5-7.
6. Re-attach the power cord and turn on
the printer. Then, run a printer self test
to verify normal operation.
Figure 5-6. Cleaning Printer Surfaces
Figure 5-7. Cleaning the Forms Tractors
BRUSH OR VACUUM
CARRIAGE PATH
WIPE SURFACES WITH
MILD DETERGENT
BRUSH OR VACUUM
FORMS TRACTORS