Setting serial parameters, Handshaking methods, Figure c-4. serial cable assembly – AMT Datasouth ACCEL-6300 User Manual
Page 176: User's guide interfaces c-11, Top view: side view
User's Guide
Interfaces C-11
Figure C-4. Serial Cable Assembly
P1
AMT/IBM PC WIRING
FROM
TO
COLOR
P1-1
P2-1
N/A
P1-2
P2-3
RED
P1-3
P2-2
WHITE
P1-4
P1-6
N/A
P1-6
P1-8
N/A
P1-8
P1-16
N/A
P1-7
P2-7
GREEN
P1-5
P2-20
BLUE
P1-20
P2-5
YELLOW
P2-4
P2-6
N/A
P2-6
P2-8
N/A
P2-8
P2-16
N/A
MOUNTING
HARDWARE
(2 EA REQ'D)
RUBBER
BUSHING
CABLE SHIELD
COPPER
FOIL
CONNECT-
ING
HARDWARE
(2 EA REQ'D)
BACKSHELL
(2-PIECE)
P2
DB-26
UNSHIELDED
WIRES
TOP VIEW:
SIDE VIEW:
Setting Serial Parameters
For successful serial communications, the computer and the printer must
use identical communications parameters. These parameters consist of
baud rate, parity, data bits, stop bits and handshake protocol. You set
these parameters—BAUD, PARITY, DATA BITS, STOP BITS and
HNDSHK—on the printer's Setup menu. For more information on
these parameters, refer to the Control Panel section of this guide.
Handshaking Methods
The printer supports three handshaking methods:
9
9
9
9
9 DTR: The DTR lines in the serial interface provide the DTR hand-
shake. To pause data transfer, the printer sets DTR low; to resume,
it sets DTR high.
User's Guide
Interfaces C-11
Figure C-4. Serial Cable Assembly
P1
AMT/IBM PC WIRING
FROM
TO
COLOR
P1-1
P2-1
N/A
P1-2
P2-3
RED
P1-3
P2-2
WHITE
P1-4
P1-6
N/A
P1-6
P1-8
N/A
P1-8
P1-16
N/A
P1-7
P2-7
GREEN
P1-5
P2-20
BLUE
P1-20
P2-5
YELLOW
P2-4
P2-6
N/A
P2-6
P2-8
N/A
P2-8
P2-16
N/A
MOUNTING
HARDWARE
(2 EA REQ'D)
RUBBER
BUSHING
CABLE SHIELD
COPPER
FOIL
CONNECT-
ING
HARDWARE
(2 EA REQ'D)
BACKSHELL
(2-PIECE)
P2
DB-26
UNSHIELDED
WIRES
TOP VIEW:
SIDE VIEW:
Setting Serial Parameters
For successful serial communications, the computer and the printer must
use identical communications parameters. These parameters consist of
baud rate, parity, data bits, stop bits and handshake protocol. You set
these parameters—BAUD, PARITY, DATA BITS, STOP BITS and
HNDSHK—on the printer's Setup menu. For more information on
these parameters, refer to the Control Panel section of this guide.
Handshaking Methods
The printer supports three handshaking methods:
9
9
9
9
9 DTR: The DTR lines in the serial interface provide the DTR hand-
shake. To pause data transfer, the printer sets DTR low; to resume,
it sets DTR high.